INSTALLATION &
OPERATING INSTRUCTIONS
1) It is very important that the
RMR-RS202 is mounted properly for optimum performance.
2) Please read these
instructions before starting your installation.
3) Determine the best location
for the RMR-RS202. For optimum performance install the RMR-RS202
on a flat surface around the front license plate area with a clear view of the
road.
4) Apply the supplied double sided tape to the RMR-RS202 on the
backside. Do not peel off both sides of tape until ready to apply to vehicle.
5) Clean thoroughly the surface
area where the RMR-RS202 will be placed using rubbing alcohol.
6) Peel off remaining side of
double sided tape and apply RMR-RS202 to vehicle. Make sure the cable
connector is facing down.
7) Do not drill any holes on
RMR-RS202.
8) Keep front lens clean and
free of debris.
Connecting your RMR-RS202
For installation with an RMR-8RD
1) Route RMR-RS202 cable
through vehicle keeping away from moving parts and hot surfaces. (Radiator
hoses, engine, etc) and pass through the fire wall under the dash.
2) Connect RMR-RS202 plug
into AUX jack on the RMR-8RD control module.
For installation without an RMR-8RD
1) Remove plug from the end of
the cable.
The green power light will illuminate on the RMR-RS202 when it is
powered on.
2) Strip the 2 wires.
3) Locate a switched +12V source
in your vehicle.
4) Connect red wire to +12V,
white wire to Ground.